Mark
Serial or Spi is just a way to communicate to the Wizfi210. And because it is a serial device with a special command set you will have to use that.
Config tcpip are for the W51/52/5300 nm7010 etc. But the Wizfi210 is a small SoC and has to get his command through serial or SPI.
If you check the datasheet and Wiznet site you get more info.
Instead of the Bascom SNTP command you will have to figure out how to send a UDP or TCP packet to a timeserver and what to do with the received packet from the timeserver.
Have fun
Ben Zijlstra
↧