Ben,
Thanks for the reply.
I looked on your main page and saw, in reference to the 7in display, more info to follow. I believe I watched the correct Youtube as it sent commands then added jumper for data on a WizFi device. Lots of info there. :)
Just didn't see the connection between the WizFi device and Bascom's SNTP and Config TCPIP.
It appears that the CONFIG TCPIP is not used when in serial mode(non SPI) and use the AT type commands to configure.
Then if that is the case then how does the Bascom SNTP function know where the device is located? The socket is passed via the function but unsure of the chipset of the WizFi210.
Regards,
Mark
↧
