Hello teccs
The meters require support for flash to be loaded on to your computer.
I have been busy for a few months getting and installing two solar systems so have had no time to work on the server.
You can change settings via the rs232 port with a terminal program like Realterm by typing Help then enter you will get instructions on commands.
You will need to load the eeprom with data and set the fuse bits on the AVR not to clear the eeprom when writing to clearing flash this is a draw back with the Arduino boards you need to connect to the board with an ISP programmer to change the fuse bits and write to eeprom but you do not need it after that.
You can use the rs232 command line to write to the eeprom and enter the IP values the ones in the code are only defaults.
It also reads the settings file and changes the values to that if they differ.
I am not at where the project is at present so it will take a few days.
What do you want to do with the project?
I have been building functions for it not all will be used in the various purposes I want to put it to so you may not need all of them.
Regards Paul
↧