hi, I lost my XP computer during Super Storm Sandy, so I bought a new computer
with Win 7 and installed a SIIG CyberParallel PCI card and the driver. I then set up
Bascom-AVR ver 2.0.7.6 to use the Sample Electronics programmer. I was not able to
program the chip, I tried all combinations of LPT1,LPT2 and LPT3 in Device Mgr with
278,378 and 3BC in Bascom-AVR and could not program the chip. My setup (breadboard,
ATMega16,cabling and test progam) is the same as I used with the XP computer. As I
recall with the XP computer I had to run setupio.exe but this file is not in the
Bascom folder on the Win 7 computer. I searched the form for info with no luck. What
am I doing wrong? PLEASE HELP ME - Dave
[b:801aeedde6][color=red:801aeedde6](BASCOM-AVR version : 2.0.7.6 )[/b:801aeedde6][/color:801aeedde6]
↧