[quote:53eccae9d3="albertsm"]you should use a sample from the w5100 folder when you use a module with the w5100.
but i still do not see which version you use. and in your last post, you did not got the error message? so now it is a different problem?[/quote:53eccae9d3]
Sorry for my late respone.
I was very busy at work.
Ok so i can't still figure it out.
It's from sample folder, but chip is changed (still ATMEGA 32).
Compile is done without error.
If i load it into the chip terminal says " init W3100A" but it's not sucessful because he didn't print next message "OK".
When i run in simulator I had the same problem.
Have someone this kind of problem? Can somebody show mi example code, where Atmega and wiznet will work?
↧