Wise gentlemen,
I have a very strange problem.
when I switch on my project, nine out of ten times, the AVR (atmega32 @ 10MHz x-tal) will not start (boot)
but sometimes it will....
then I get 145KHz on several pins (pin 1,2,3,4,5, 7,8, 19) this is where my 128x64 ks0108 is connected
when i slowly raise the voltage of my project (from 0 to 5v in 3 seconds),the avr starts 100% of the times
????
Can somebody help me with this please, I only have 10 hairs left.
Wilfred
the workaround is a slow start with LM317 but there should be a way in software or fuses (i hope )
Wilfred
[b:2eacabacc7][color=red:2eacabacc7](BASCOM-AVR version : 2.0.6.7 , Latest : 2.0.7.6 )[/b:2eacabacc7][/color:2eacabacc7]
↧