I am new to the CAN BUS and tried the BASCOM CAN bus test program for a start .
I get the following compile error :
Error : 117 Line : 23 Unknown interrupt [CANIT] , in File : C:conveyorcancontrolelektorcancode.bas
Error : 72 Line : 60 Getclass error [ 23] , in File : C:conveyorcancontrolelektorcancode.bas
Error : 72 Line : 60 Getclass error [ 23] , in File : C:conveyorcancontrolelektorcancode.bas
Error : 7 Line : 60 IF THEN expected [ 60] , in File : C:conveyorcancontrolelektorcancode.bas
Error : 123 Line : 60 END IF expected , in File : C:conveyorcancontrolelektorcancode.bas
This is the sample program - did not change one bit if it .
Why do I get all this errors from a sample program - also tried the code from the Elektor May 2013 article and same happens.
I checked the m32can.dat file to see if the " canit " is a valid interrupt name and yes it is listed there.
I use :
Don't forget that Serial numbers should not be sent to the user list.
Make sure you sent your email to support and not a public list !
Compiler version :2.0.7.6
Compiler build :2.0.7.6.001
IDE version :2.0.7.6.001
Serial number :DT-xxxxxxxx
Please help
Cheers
Nico
↧